| <TABLE border="0" cellSpacing="0" cellPadding="0" width="95％" align="center">
<TBODY>
<TR>
<TD height="10"></TD>
</TR>
<TR>
<TD height="30" align="middle"><SPAN ><U><strong>Installation of diesel generator set points</strong></U></SPAN> </TD>
</TR>
<TR>
<TD height="10" align="middle"></TD>
</TR>
<TR>
<TD vAlign="top"><SPAN >1, the installation locations for a well-ventilated, generators, air inlet side should be sufficient, diesel engine the outlet side should be good.</SPAN> <SPAN >Outlet area should be more than 1.5 times greater than the water tank area.</SPAN> <BR>
<SPAN > 2, the installation should be kept clean around the ground to avoid the place in the vicinity to produce acidic, alkaline and other </SPAN><SPAN > Fire extinguishing system should be configured conditions.</SPAN> <BR>
<SPAN >3, for indoor use, must be guided through the outdoor exhaust pipe, diameter of the muffler must be ≥ pipe diameter, the connection of the elbow pipe not more than 3, to ensure the smooth flow of exhaust gas and the tube should be downward 5-10 degrees, to avoid the rain into; if the exhaust pipe installed vertically upward, you must install rain cover.</SPAN> <BR>
<SPAN > 4, the base with concrete, the installation shall be measured by the level of foot level degrees, the unit fixed on the basis of the level.</SPAN> <SPAN >Between the unit and the basis of special anti-vibration pads or should be the end of bolt.</SPAN> <BR>
<SPAN >5, the unit housing must be a reliable protective earth, on the need for grounding the generator neutral point directly, it must be grounded by the professionals in neutral, and configure the lightning protection device, non-use of electricity in the neutral grounding device directly to ground.</SPAN> <BR>
<SPAN >6, the generator and utility must be very reliable two-way switch to prevent reverse transmission.</SPAN><SPAN >The reliability of two-way switch wiring the electricity sector subject to the inspection of local recognition.</SPAN> <BR></TD>
</TR>
</TBODY>
</TABLE> |